ST200–260 injection molding servo motor

CATALOGUE OVERVIEW

About this motor series

Jianghuai identifies ST200–260 as a servo motor series for injection-moulding machines. The official entry names the series and application, but its current product-detail body does not include a downloadable performance table or numerical ratings.

For an injection-moulding drive inquiry, provide the machine cycle, pressure and flow requirements where a hydraulic pump is driven, required shaft torque and speed, overload duration and cooling conditions. Request the exact ST model, drive compatibility, feedback interface, inertia and mounting drawing from Jianghuai. Confirm that the offered motor and controller meet the machine duty rather than using the series number as a power rating.

Published specifications

Use these ratings to shortlist the series. A range does not mean every combination is available.

Power

Confirm configuration

Voltage

Confirm supply

Speed

Model dependent

Selection

Specify supply, duty and mounting with your inquiry

Manufacturer

Jianghuai Motor

Catalogue Type

Product series

Not stated in the collected source: exact price, MOQ, lead time, model-specific dimension drawing. Request these with your selected configuration.

Selection priorities for Servo motors

Peak torque alone does not describe continuous capability. Ask for the torque-speed curve, duty conditions, inertia and the matching drive specification.

• Continuous and peak torque
• Speed and motion profile
• Encoder or resolver interface
• Drive compatibility
• Brake and cable options

Use the ST200–260 injection molding servo motor reference when requesting a datasheet from Jianghuai Motor. Confirm these requirements against the exact offered model before comparing quotations.

Send a specification the manufacturer can quote

1. Application and load: describe the machine, required torque or power, speed and operating cycle.
2. Electrical supply: provide voltage, frequency, phase and any inverter or controller.
3. Installation: share mounting, shaft dimensions, frame constraints and operating environment.
4. Commercial requirements: state quantity, destination, target date and required certificates or drawings.