YTD100 permanent-magnet automatic-tool-change spindle

CATALOGUE OVERVIEW

About this motor series

Xuchang's YTD100 automatic-tool-change spindle table distinguishes two permanent-magnet variants rather than one continuous specification envelope. The 8 kW version is rated at 14500 rpm, 483 Hz and 14.6 A; the 12.5 kW version is rated at 24000 rpm, 800 Hz and 22.5 A. Both use a 380 V supply, but their maximum speeds are separately listed as 24000 and 34000 rpm respectively. The catalogue identifies four poles, an encoder, grease-lubricated bearings and internal water or oil cooling, with HSK40 or BT30 interface options. Buyers should confirm the chosen tool interface and clamping system, coolant conditions, inverter matching and allowable machining loads. Do not use the higher variant's power together with the lower variant's current or rated-speed values.

Model / series reference: YTD100

Published specifications

Use these ratings to shortlist the series. A range does not mean every combination is available.

Power

8–12.5 kW

Voltage

380 V

Mass

17 kg

Poles

4

Cooling

Internal water or oil circuit

Interfaces

HSK40 / BT30 options

Tool Change

Automatic

Rated Torque

5.2 Nm (8 kW); 5.0 Nm (12.5 kW)

Maximum Speed

24000 rpm (8 kW); 34000 rpm (12.5 kW)

Rated Variants

8 kW / 14.6 A / 483 Hz / 14500 rpm; 12.5 kW / 22.5 A / 800 Hz / 24000 rpm

Speed

Model dependent

Request current pricing, MOQ, lead time and a dimensioned drawing for the exact configuration offered. Catalogue drawings may cover several variants.

Catalogue reference

Manufacturer

Xuchang

Product reference

YTD100 permanent-magnet automatic-tool-change spindle

Source reviewed

2026-09-23

Specifications describe the manufacturer’s published catalogue. They are not a test report or a guarantee that every option can be combined.

Send a specification the manufacturer can quote

1. Application and load: describe the machine, required torque or power, speed and operating cycle.
2. Electrical supply: provide voltage, frequency, phase and any inverter or controller.
3. Installation: share mounting, shaft dimensions, frame constraints and operating environment.
4. Commercial requirements: state quantity, destination, target date and required certificates or drawings.