MOTOR MANUFACTURER · Zhejiang, CHINA

Dongling Motor

Wenling Dongling's published DL-PS range is built around sensorless three-phase permanent-magnet synchronous motors paired with a suitable vector-control drive; its DL-PG-PS entry adds a gearbox. The catalogue also includes a DL-FS generator family, which answers a different procurement question. For a conveyor, pump or geared axis, a buyer needs the operating torque-speed point, low-speed cooling and output interface before comparing headline motor power. The public pages do not establish a universal inverter or gearbox combination for every model.

LocationZhejiang, China
Published catalogue4 product series
Motor families3 represented

DONGLING · PERMANENT-MAGNET DRIVE SYSTEMS

Dongling Motor: specify the PM motor, inverter and gearbox together

Explore the published range ↓

01 / MOTOR, CONTROL AND OUTPUT

Decide which part of the drive Dongling is supplying

DL-PS IC410: self-cooled motor and matched vector drive

The Chinese DL-PS(IC410) product information identifies a sensorless three-phase permanent-magnet synchronous motor, an intended permanent-magnet vector inverter and IC410 self-cooling. A motor-only price cannot tell a buyer the delivered low-speed torque or temperature rise. The inverter parameter set, supply, cable run and continuous speed range belong in the selection, especially where the machine spends long periods below base speed.

Confirm before ordering Ask for exact motor code, torque-speed curve, continuous low-speed duty, inverter make/model and settings, supply, overload duration, feedback or sensorless operating limits, and the cooling basis at the intended speed.

View DL-PS IC410 permanent-magnet synchronous motor →

DL-PG-PS IC410: geared output is the purchase point

Dongling's separate DL-PG-PS(IC410) page describes a sensorless PM synchronous motor with vector inverter and an integrated geared output, also identified as IC410 self-cooled. The motor's rotor speed, gearbox ratio and delivered output-shaft speed are not the same quantity. A geared assembly must be checked for allowable output torque, service duty, direction and shaft/flange geometry as one offered configuration.

Confirm before ordering State required loaded output rpm, running and peak torque, starts and reversals, gearbox ratio, mounting, shaft/key, ambient temperature and drive supply. Request an assembly drawing and allowable gearbox torque for the exact ratio.

View DL-PG-PS IC410 permanent-magnet synchronous gearmotor →

DL-PS IC411: cooling choice changes the duty discussion

Another official DL-PS page identifies IC411 fan cooling with the same sensorless PM/vector-drive concept. IC410 and IC411 are distinct cooling descriptions, not interchangeable labels. A fan-cooled motor's behavior at a sustained low electrical frequency cannot be assumed from a self-cooled version or from nominal-kW text alone; seek a tested operating envelope for the offered motor and drive.

Confirm before ordering Have Dongling identify IC410 or IC411 on the offered nameplate and provide the applicable thermal limits across the operating-speed range; confirm whether any separately powered ventilation is required.

View DL-PS three-phase permanent-magnet synchronous motor →

02 / WHAT THE WEBSITE DOES AND DOES NOT PROVE

Do not mix a PM drive with a generator or an unclear rating

DL-FS is a generator enquiry

The official DL-FS page calls this a low-speed permanent-magnet generator for wind and off-grid-type uses, describing a three-phase rectifier and 12/24/48 V DC output options. That is not a DL-PS motoring duty or a drop-in geared motor. The same page prints a power field as '3-10V', a voltage unit; do not translate that into a verified power rating. Ask for a current electrical-output curve and rectifier/load design if generation is the actual project.

View DL-FS wind generator →

An IP label needs the exact build

The official DL-PS and geared pages print a compressed 'IP54IP56' protection field. That could refer to variants, but the public text does not say which is supplied. State the operating environment and ask for the specific IP rating, enclosure construction and test evidence on the quoted build rather than repeating both as guaranteed.

Company claims are not a model certificate

Dongling's own introduction says it develops and makes permanent-magnet motors in Wenling and mentions management and product certifications. The accessible public company text does not establish that every DL-PS configuration has a current approval or has been independently endurance-tested for a buyer's duty. Request evidence for the exact offered variant.

03 / REDUCE REWORK BEFORE PRICING

Describe one operating point and one deliverable package

The useful commercial unit here is often a motor, control setup and mechanical output considered together. Specify whether the request is for a bare motor, geared drive, configured inverter package or a generator; then require the supplier to mark which parts and tests are included.

Machine and electrical brief

Provide load torque versus speed, acceleration, starting and reversal duty, hours at low speed, supply voltage/frequency, ambient and ingress conditions, noise constraint and allowable downtime. Request continuous/peak torque curves and current-draw data for the exact motor-plus-drive pairing.

Mechanical fit and controls

For a retrofit, attach old nameplate, drawing, flange and shaft measurements, coupling and gearbox details. State required I/O, communications, speed feedback and protection behavior. Ask for inverter model, parameter file, wiring diagram and complete geared-assembly drawing if applicable.

Acceptance evidence

Ask Dongling to identify the precise cooling method, IP rating, insulation class and duty for the offered unit; request the current datasheet and any relevant model-specific test report. A catalogue family name or a company-level certification claim is not a substitute for these documents.

Published motor range

4 series
DL-FS wind generator

DL-FS wind generator

Ask about this series and the configuration that fits your application.

Company information

Company name
Wenling City Dongling Motor CO.,LTD.
Chinese registered name
温岭市东菱电机有限公司
Region
Zhejiang, China
Record updated
2026-10-07

Share with your team

Keep your sourcing team on the same page.

LinkedInFacebookXWhatsAppEmail