TZL22-0.2kW parking-system gearmotor

Manufacturer catalogue image · Series illustration

Geared motors

TZL22-0.2kW parking-system gearmotor

Power
0.2 kW
Voltage
380 V
Frequency
50 Hz
Brake Supply
DC 90 V

Catalogue series · Exact configuration and availability confirmed by the manufacturer.

TZL22-0.2 kW: a smaller drive changes the mounting and brake duty

The TZL22 occupies less space than the TZL28, but it also changes shaft size, centre height and mounting-hole spacing. Its brake table lists 20 operations per minute, a model-specific entry that should not be borrowed from a larger TZL assembly. Use the exact 0.2 kW drawing when fitting a compact parking mechanism.

Replacing a TZL28 requires more than a smaller motor rating

Dimensions are taken from the separate 0.2 kW TZL22 and 0.75 kW TZL28 sheets. This is a fit comparison, not a recommendation to substitute the lower-powered assembly.

Installation itemTZL22-0.2 kWTZL28-0.75 kW
Overall length 312.5 mm 375.5 mm
Output shaft / extension 22 mm h6 / 40 mm 28 mm h6 / 45 mm
Shaft centre above base 90 mm 116 mm
Mounting spacing, longitudinal × transverse 65 × 130 mm 90 × 140 mm
Four mounting-hole diameters 11 mm 12 mm
Key-width callout 6 mm 8 mm

Verify the complete movement against the small brake’s data

20 operations per minute belongs to this brake row

The TZL22 sheet lists 20 operations per minute, 0.07 s braking time, 0.02 s release time and 0.4 kg-m brake torque. It does not describe the load inertia or an unlimited repeated operating cycle for the whole machine. Supply the intended starts, stops and loaded travel time when confirming the duty.

Coil voltage and motor voltage are different

The motor is a four-pole 380 V, 50 Hz, three-phase unit rated at 0.5 A and 1,400 rpm. Its brake is DC 90 V with AC 200–240 V rectifier input. Specify the rectifier and switching circuit with the assembly and verify how the controller coordinates brake release and motor operation.

Keep the adjustment accessible

The listed brake air gap is 0.3 mm, with 0.7 mm as the boundary value. The mounting layout needs access for inspection and adjustment as well as room for the compact motor. The sheet does not give a wear-based maintenance interval, so no fixed service interval is assumed here.

Match output speed and torque from the same ratio row

The catalogue uses kg-m for torque. Its separate 200 kg load entry lacks the mechanism geometry and complete lifted-mass definition, so it is not a general vehicle-capacity rating.

Reduction ratioOutput speedOutput torque (kg-m)
1:30 47 rpm 3.7
1:40 35.2 rpm 4.9
1:50 28.3 rpm 6.1
1:60 22.2 rpm 7.4
1:70 19.6 rpm 8.9
1:90 14.8 rpm 11.1

CATALOGUE OVERVIEW

About this motor series

Zhibao’s TZL22 is a compact parking-system gearmotor with a 0.2 kW, four-pole motor at 380 V, 50 Hz and 1400 rpm. Its gearbox table lists ratios from 1:30 to 1:90 and output speeds of 47–14.8 rpm. The shaft is specified as 22 mm h6 and the assembly length is 312.5 mm. A DC 90 V brake is included in the specification table. Check the output shaft, bolt pattern and required stopping cycle together.

Model / series reference: TZL22

Published specifications

Specifications describe a series range; confirm which ratings apply together to the quoted model.

Power
0.2 kW
Voltage
380 V
Frequency
50 Hz
Brake Supply
DC 90 V
Motor Output
0.2 kW
Output Shaft
22 mm h6
Output Speed
14.8–47 rpm
Product Type
TZL22-0.2kW parking-system gearmotor
Catalogue Scope
Manufacturer model or series
Reduction Ratios
1:30 / 40 / 50 / 60 / 70 / 90
Motor Rated Speed
1400 rpm
Speed
Model dependent
Manufacturer
Shanghai Zhibao

Confirm mounting and shaft dimensions against the drawing for the quoted configuration.

Share with your team

Keep your sourcing team on the same page.

LinkedInFacebookXWhatsAppEmail